Troubleshooting About Pillow Type Packing Machine

By:Sherry         Date:April-20-18

Pillow type packing machine common error tips and handling methods:
1. Photoelectric error:
a. When the status bar shows photoelectric errors and has alarm sound, please adjust the sensitivity of the photoelectric eye, the photoelectric eye sensitivity is adjusted too high or too low will cause the above failure.
b. The setting value of the package length does not match the length of the actual packaging bag will cause the above failures, but the system design has automatic measurement length function, when you use the packaging bag with a cursor, It is recommended to set the measurement to automatic to avoid incorrect setting of the package length.
 
2. Itinerary error:
When the status bar shows a trip error and an alarm sound, check the travel switch.
 
3. Can not measure the length automatically:
Remedy: Set the length measurement to automatic measurement.
Affirmation: due to the different models and the continuous improvement of the control system software, the actual procedure is based on the instructions.
 
4. Pillow packaging machine use matters needing attention:
a. If any dirt is stuck on the heating block when operating the packing machine, stop the operation of the machine, remove the dirty items, and prevent the melt from flowing into the machine to cause damage.
b. Reduce the idling of the machine. If it is not used for a long time, it should be turned off to avoid equipment wear.
c. When the machine is working, it is not allowed to place hand in a hot place to avoid physical injury.
d. If you do not use the machine for a long time, clean it up, apply grease on the relevant parts, and attach a cover to prevent dust from entering the core of the machine and causing damage to the machine.
 
If you pay attention to the above matters during operation, you can not only extend the life of the pillow type packing machine, but also save maintenance costs.